AmyS
|
| Posted: 06/18/2006, 5:00 PM |
|
I have three tables similar to the example.
Table 1 ia tbl_cyl-model with ModelID & ModelName
Table 2 is tbl-cyl_size with ID, ModelID and CylinderSize
Table 3 is tbl_cyl_dia with ID, CylinderSize and PistonDiameter
I have followed the Implementing multiple dependent drop-down menus and get
stuck at Item 4. Switch to tthe HTML mode.... It says to add the JavaScript
code as shown in the example. I am guessing it is the example you mention
at the beginning of the page, right?
I put that code in but do not see the <!--BEGIN Grid...--> and <!--END
grid...--> except at the bottom of the html. Is that where is is suppose
to be?
Then obviously my tables aren't going to match, so I have modified the steps
above for my tables.
On steps 5 and 6, where do I insert the new Grid Builder?
And where is says to add new code to BEGIN separator after the Row Block, it
is very confusing. This would be helpful if there were images or diagrams
showing what you are talking about.
I would appreciate any help.
Thanks, Amy
|
|
|
 |
|
