kklouccs
Posts: 12
|
| Posted: 09/26/2007, 9:46 PM |
|
Hi, all higher hands,
In html mode, i made a panel to show/hide the lines above and including the tags <html><body> and another panel for the lines under and including the tags </body></html>.
when i switched to design mode, made some changes, then went back to html mode, these panels relocated by CCS unexpectedly, they are all placed in-between the tags <body> and </body>.
Can i config CCS not to touch my hand-made html code?
if not, Can anyone tell me how to work around it.
If possible, YesSoftware, pls adjust CCS not to move these panels, in next bug-fix release.
thanks in advance
|
 |
 |
wkempees
|
| Posted: 09/27/2007, 12:58 AM |
|
You are in CCS 3.2 then?
Have you tried inserting the Panel in Design mode instead of HTML Mode.
Just drop in the Panel, name it, and then move the subsequent piece of
design into the Panel?
Walter
|
|
|
|
kklouccs
Posts: 12
|
| Posted: 09/28/2007, 8:20 AM |
|
Hi,
Yes, i am using CCS 3.2.
i have tried to insert the panels in design mode, but it never places the panels across the <html><body> tags, it always places the panels in between the <body> and </body> tags.
i need the panel like the following:
<!-- BEGIN Panel Panel1 -->
<html>
<body>
<!-- END Panel Panel1 -->
and so on ...
it works in CCS, but my problem is the <!-- BEGIN Panel Panel1 --> will be relocated to the line under the <body> tag whenever i make any change in design mode.
i am expecting CCS not to touch my hand-made html, or give me a button to switch-off this feature in CCS?
Would YesSoftware consider my expectation?
Can anyone advise me how to work around it?
|
|
|
|
wkempees
|
| Posted: 09/28/2007, 3:35 PM |
|
report to support please, soonest.
They can figure out if this is an unwanted bug.
Walter
|
|
|
|
kklouccs
Posts: 12
|
| Posted: 09/29/2007, 1:02 AM |
|
hi, Walter (wkempees),
thanks for your advice.
i have sent to support.yessoftware.
|
|
|
|
|
